DIYHD Ornate Cut Roller Black authentic Iron Sliding barn door hardware

Material:Steel,Serface:Black

Hardware Only,Not Including Door Panel;Material:Steel,Serface:Black

The height from top of the door to the top of the roller is 127mm(5"),please at least 150mm(6") for installation

The gap between door and wall is 16mm(3/5") based on door thickness 45mm(1 4/5")

Door panel need to be cut a groove for floor guide,Groove Height:1"*Width:3/10"


extra roller set including:
Roller*2,
Anti-pad*2,
Floor guide*1

5ft/5.5ft single kit including:
roller*2pcs;
stop*2pcs;
5ft/5.5ft track*1pcs;
track&wall connector*4pcs;
anti-pad*2pcs;
floor guide*1pcs;


6ft/6.6ft single kit including:
roller*2pcs;
stop*2pcs;
6ft/6.6ft track*1pcs;
track&wall connector*5pcs;
anti-pad*2pcs;
floor guide*1pcs;

8ft single kit including:
roller*2pcs;
stop*2pcs;
4ft track*2pcs;
track connector*1pcs;
track&wall connector*6pcs;
anti-pad*2pcs;
floor guide*1pcs;


10ft single kit including:
roller*2pcs;
stop*2pcs;
5ft track*2pcs;
track&wall connector*8pcs;
track connector*1pcs;
anti-pad*2pcs;
floor guide*1pcs;


8ft double kit including:
roller*4pcs;
stop*4pcs;
4ft track*2pcs;
track connector*1pcs;
track&wall connector*6pcs;
anti-pad*4pcs;
floor guide*2pcs;


10ft/11ft double kit including:
roller*4pcs;
stop*4pcs;
5ft/5.5ft track*2pcs;
track&wall connector*8pcs;
track authentic connector*1pcs;
anti-pad*4pcs;
floor guide*2pcs;

12ft/13ft double kit including:
roller*4pcs;
stop*4pcs;
6ft/6.6ft track*2pcs;
track&wall connector*10pcs;
track connector*1pcs;
anti-pad*4pcs;
floor guide*2pcs;


16ft double kit including:
roller*4pcs;
stop*4pcs;
4ft track*4pcs;
track&wall connector*12pcs;
track connector*3pcs;
anti-pad*4pcs;
floor guide*2pcs;

How to install barn door hardware
Step1:Prepare door panel and hardware
Door panel pre-cut groove,Groove Height:1"*Width:3/10"
Prepare gasket or wooden board/thick spacer if you have thick frame/baseboard

Step2:Drill 16" apart holes on the wall
The height of the place where drill hole is door height +43mm(1 11/16")
Double check the level then tight the track on the wall with spacer

Step3:Dill holes on the door and tight the roller,than hang door panel on the track

Step4:Fix the Anti-pad on the top of the door
The anti-pad can reduce the gap between door and track to make full system safety

Step5:Install floor guide on the bottom of the door

Step6:Install stops on two sides on the track